5/15/2018 · Just a tip on installing zerk fittings on a driveshaft so you can actually grease the joint .
5/4/2020 · This is where the U-Joint is located. The grease fitting point is located in the center of the U-Joint. If you cannot see the grease fitting point, rotate the drive shaft slowly by hand into the grease fitting direction until you reach it properly. Step 3: Grease U-Joint: Using grease gun and the right size grease gun coupler, start filling the grease into the filling home. Continue filling the grease until you see clean.
How to grease U joints and How it Works ? – Rx Mechanic, How to grease U joints and How it Works ? – Rx Mechanic, How to grease U joints and How it Works ? – Rx Mechanic, How to grease U joints and How it Works ? – Rx Mechanic, When the U-joint is installed properly, articulation will be free and equal in all directions. If binding occurs, it is usually an indication that the yoke or a cup is not properly positioned. However, if binding is the result of yoke deformation, support the shaft and apply force (Figure 4), then recheck articulation.
A U – joint is an equal-legged cross with needle roller bearings on its four ends covered with a cap that retains grease for the bearings. A driveshaft or a half-shaft will have two U – joints – one on either side – or it may have a U – joint on one end and a CV joint on the other. The driveshafts are balanced for smooth, vibration-free rotation.
2/26/2011 · The only U-joint that I have had a problem with is the front one, what I found works the best for me is to turn the front wheel until the u-joint opens to the point that you can fit the grease fitting in and then using a wrench a loosen the nipple turning into the opening until I can put the grease fitting on it and then tighten it afterwards.
